Universal Hammer
HAMMER


 
COMPATIBILITY:
Fits midblock or full body guns including WGP, Empire and Inception
* Empire and WGP are licensed trademarks of G.I. Sportz
Price: $29.95


: IFP-1018
Qty:

Description
 
This polished stainless steel hammer is a "MUST HAVE" upgrade for the Empire Sniper and Empire Resurrection. It moves the hammer cocking point further back so the gun only cocks when the bolt has cleared the breech and will allow the next ball to drop. This helps prevent short stroking the gun and breaking paint. This hammer is 10% heavier than the stock Empire Sniper and Empire Resurrection hammer. This means you can back out the IVG to approximately flush with the back of the gun and still get full velocity. With a pump gun this means the pump stroke to cock the gun will be lighter and smoother. With an Autococker this means you can get a fast rear cocking stroke, run lower LPR pressures, and make the gun gentler on how it handles paint. This is a UNIVERSAL hammer that can be used in ANY Midblock or full body guns including those older guns from WGP as well as the newer guns from Empire and body kits from Inception Designs. It has the cocking slot milled on the top, and the back is threaded for 10-32 cocking rods. It comes with a hardened hammer lug, urethane friction plug to stop the hammer lug from moving, and a locking set screw to tension the urethane plug. It has an extra threaded hole in 10-32 which can be accessed from the hammer slot in the body and can be used to tighten a nylon set screw against the cocking rod to prevent it from coming loose. Cocking rods, with nylon set screws are available separately.

Inception Designs | Heavy Hammer

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 2 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 Does what Simon say it does. October 1, 2018
Reviewer: Eric Klein from Simpsonville, SC United States  
Moves the cocking point a little further back.  I can run the IVG flush and still hit chrono speed.  So far this is one of thoes just buy it mods...This is the way the ressy should have come from the factory.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Very desirable features October 1, 2018
Reviewer: Scott Rieger from Forked River, NJ United States  
Bought one of these when they first came out for my ripper. Not only did it correct the cocking point and allow my bolt to clear the breach fully, but it allowed me to lower my operating pressure. It's slightly heavier of a hammer and because of that my fps went up to 305 from the stock hammer touching nothing else. Slight decrease in my pressure, set the ivg to flush and it works great!

Was this review helpful to you?